| For use on the:
Megatest Q2/52 & Q2/62 Test Systems Megatest Q8000 Test System EPRO 140, 142A, & 142AX Test Systems Desktop ‘‘Stand-Alone” TimerInterface with other Test Systems Description: The Quest Bin Box was designed to display the signals that pass between the Handler/Prober and the Test System. The signals “ Interface BIN x ” are displayed and are not available on the front panel. The total Test Time is displayed during each test and freezes when the test ends. The Bin Box has a “ Loop ” switch that allows the tester to continually re-test one part or to just repeat a Test Program. |
|
|
Features:
- The Quest Bin Box is small and can be located in any convenient location for ease of use.
- Handler/Prober plugs into back of Bin Box to allow for easy connections. Do not have to go to the rear of the Test
System to connect the handler/prober. - Displays the following:
- TEST TIME – displays the test time in ‘ tenths’ or ‘ hundreds’ of a second from ‘ Start Test’ to ‘ End of Test’ signals. Test Time is displayed in 4 digits up to either 1:40 minutes (99.99 sec) or 16:40 minutes (999.9 sec) – an ‘overflow’ LED lights is counter exceeds count limit.
- INTERFACE Bins – Bins 1 to 6 and ‘special’ Bin 7 (displays ‘ 0 ’ if no bin selected)
- PASS LED and 3 FAILURE LEDs – ParFail, FunFail, OpenFail
- TESTING and END-of-TEST LEDs
- RETEST LED – from Tester (Retest) and from Handler (HRetest)
- Results of last test are continued to be shown but ‘ dimmed’ while next test is running.
- LOOP Mode Switch – Allows continuous testing to occur. When one test ends a new test is automatically initiated. Used in burn-in, repeated testing of one device, debug.
- “START TEST” button is used to initiate Testing
- The Quest Bin Box can be removed from the Tester and used as a “general purpose” desktop timer.
- Accepts +5V or +12V Signal levels from Handler, active HIGH or LOW.
- The Quest Bin Box is stocked at Quest for Off-the-Shelf Delivery.
- TEST TIME – displays the test time in ‘ tenths’ or ‘ hundreds’ of a second from ‘ Start Test’ to ‘ End of Test’ signals. Test Time is displayed in 4 digits up to either 1:40 minutes (99.99 sec) or 16:40 minutes (999.9 sec) – an ‘overflow’ LED lights is counter exceeds count limit.
